Sunroof - Service Information: Glass: Adjustments: Adjustment
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Move the sunshade rearward to the open position.
- Separate the mechanism covers (2) from the tabs (1) on the glass panel.
- Verify the sunroof glass panel is in the fully closed position.
- Loosen the forward attaching screws (3) on each side enough to permit the front of the glass to adjust up or down.
- Adjust the front surface of the sunroof glass panel 0.00 mm to 2 mm (0.00 in. to 0.08 in.) below the top surface of the roof.
- Tighten the front glass panel attaching screws to 3.5 N.m (30 in. lbs.).
- Loosen the rear screws (3) on each side enough to make the rear adjustment.
- Adjust the rear surface of the sunroof glass panel 0.00 mm to 2 mm (0.03 in. to 0.08 in.) above the top surface of the roof.
- Tighten the rear glass panel attaching screws to 3.5 N.m (30 in. lbs.).
- Check for proper fit. If not OK, repeat glass panel adjustment.
- Position the mechanism covers (2) over the glass tabs (1) between the locating features and seat fully.
- Verify sunroof operation and alignment.