Seat Back-Rear: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Rear Seat Back Mounting Bolts

Courtesy of DAIMLERCHRYSLER CORP.

Place the rear seat back into position by slipping the hinge bracket onto the two outboard lower bolts.
Install the other four mounting bolts (1). Remember to install the three inner seat belt buckles. Torque the bolts to 50 N.m (37 ft. lbs.).

Fig 2: Identifying Rear Seat Belt Anchor
Courtesy of DAIMLERCHRYSLER CORP.
Slide the two outboard seat belt anchors (2) onto the outboard lower bolts (1). Tighten bolts to 50 N.m (37 ft. lbs.).
Install the rear seat cushion (Refer to BODY/SEATS/SEAT CUSHION - INSTALLATION) .