LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 540 (Body - Interior & Exterior) >> Seats >> Cushion/Cover-Cushion - Front >> Removal

Cushion/Cover-Cushion - Front: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Bolts & Clamps
GC0027972Courtesy of DAIMLERCHRYSLER CORP.
  1. Before proceeding with the following repair procedure, review all warnings and cautions. (Refer to BODY/SEATS - WARNING) 
  2. Move the seat to the forward position and disconnect and isolate the batter negative cable.
  3. Remove the bolts (2) and the clamps (1) and remove the seat cushion.
  4. Disconnect the electrical connector, if equipped.
    Fig 2: J-STRAPS
    GC0027974Courtesy of DAIMLERCHRYSLER CORP.
  5. Separate the j-straps (1 & 2) and seat cushion cover and foam.
scientia non olet · About LEMON Manuals