LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 540 (Body - Interior & Exterior) >> Exterior >> Body Side Moldings >> Removal

Body Side Moldings: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a length of masking tape on the body, parallel to the top edge of the molding to use as a guide, if necessary.
  2. Warm the effected adhesive type molding and body metal to approximately 38°C (100°F) using a suitable heat lamp or heat gun.
  3. Pull stick-on molding from painted surface.
scientia non olet · About LEMON Manuals