Doors - Rear: Door: Removal
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable.
- Disconnect the rear door wire harness connector from the body wire harness.
- Using a grease pencil or equivalent, mark the location of the rear door hinges (2 and 3) on the B-pillar.
- Support the rear door with a suitable lifting device and remove the four bolts (1 and 4) that secure the rear door hinges to the B-pillar.
- Carefully remove the door from the body.
- If required, remove the rear door hinges from the door (Refer to BODY/DOORS - REAR/HINGE - REMOVAL) .