LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 539 (Fuel System) >> Fuel Injection >> Sensor-Oxygen >> Installation

Fuel Injection: Sensor-Oxygen: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal. DO NOT add any additional anti-seize compound to threads of a new oxygen sensor. 

  1. Install O2S sensor. Tighten to 30 N.m (22 ft. lbs.) torque.
  2. Connect O2S sensor wire connector.
  3. Lower vehicle.
scientia non olet · About LEMON Manuals