3.7L V-6

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be careful not to damage or kink cable core wire (within cable sheathing) while servicing accelerator pedal or throttle cable.

Fig 1: Removal & Installation Of Throttle Control Cable

Courtesy of DAIMLERCHRYSLER CORP.

From inside vehicle, hold up accelerator pedal. Remove plastic cable retainer (clip) (2) and throttle cable core wire from upper end of pedal arm. Plastic cable retainer snaps into top of pedal arm.
Remove cable core wire at pedal arm.
From inside vehicle, remove metal clip holding cable (3) to dash panel.
Remove air resonator box at throttle body.
Unsnap cable from dash panel routing clip.
Remove cable housing from dash panel and pull into engine compartment.

Fig 2: Identifying Slide Throttle Cable Pin - 3.7L V-6
Courtesy of DAIMLERCHRYSLER CORP.
Hold throttle in wide open position. While held in this position, slide throttle cable pin (1) from throttle body bellcrank.

Fig 3: Identifying Throttle Cable Release Tab - 3.7L V-6
Courtesy of DAIMLERCHRYSLER CORP.
Using a pick or small screwdriver (3), press release tab (2) to release plastic cable mount from bracket. Press on tab only enough to release cable from bracket. If tab is pressed too much, it will be broken. Slide plastic mount (4) towards right side of vehicle to remove throttle cable from throttle body bracket.
Remove throttle cable from vehicle.