LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Rack & Pinion Power Steering System) >> Pump - Service Information >> Reservoir >> Removal >> Fluid Reservoir - 3.7L & 4.7L

Fluid Reservoir - 3.7L & 4.7L

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Reservoir Mounting Bolt
GC0027326Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove power steering pump (Refer to STEERING/PUMP - REMOVAL) .
  2. Clean exterior of pump.
  3. Clamp the pump body in a soft jaw vice.
  4. Remove the mounting bolt (3) from the side of the reservoir (2).
    Fig 2: Pump With Reservoir
    GC0027327Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove the 2 reservoir mounting bolts (7) to the pump (4).
    Fig 3: Reservoir From Pump
    GC0027325Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove fluid reservoir (1) from pump body (2). Remove and discard O-ring seal.
scientia non olet · About LEMON Manuals