Pressure Line - Fan To Pump
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Install the pressure line(5) to the vehicle.
- Install the pressure line (5) at the hydraulic cooling fan filter (2).
- Reconnect the electrical connector (6) for the pressure switch (1).
- Install the front skid plate.
- Lower the vehicle.
- Install the pressure line at the pump Tighten to 28 N.m (21 ft.lbs.).
- Fill the system with power steering fluid.
- Bleed the DHS system using a scan tool (Refer to STEERING/PUMP - STANDARD PROCEDURE) .