Pressure Hose - Gear To Pump
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - PUMP ASSEMBLY |
| 2 - PRESSURE HOSE PUMP TO GEAR |
| 3 - RETURN HOSE - RESERVOIR TO FLUID COOLER |
| 4 - FLUID COOLER |
| 5 - RETURN HOSE - STEERING GEAR TO FLUID COOLER |
| 6 - MOUNTING BRACKETS |
| 7 - STEERING GEAR |
- Install the line (2) to the vehicle.
- Install the three mounting brackets (6) for the pressure line (2) to the engine cradle.
- Reconnect the power steering pressure line (2) to the power steering gear (7) Tighten to 28 N.m (21 ft.lbs.).
- Reconnect the power steering pressure line (2) to the power steering pump (1) Tighten to 28 N.m (21 ft.lbs.).
- Refill the power steering fluid and bleed the system, (Refer to STEERING/PUMP - STANDARD PROCEDURE) .