LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 536 (Anti-Lock Brake System (Service Information)) >> Sensor-Front Wheel Speed >> Removal

Sensor-Front Wheel Speed: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the caliper adaptor bolts. Support the caliper and adaptor assembly Do Not let assembly hang by the hose. (Refer to BRAKES/HYDRAULIC/MECHANICAL/DISC BRAKE CALIPERS - REMOVAL) .
  4. Remove the disc brake rotor (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - REMOVAL) .
    Fig 1: Wheel Speed Sensor
    GC0026763Courtesy of DAIMLERCHRYSLER CORP.
    1 - WHEEL SPEED SENSOR WIRE
    2 - NUT
    3 - HUB/BEARING
  5. Remove the front wheel sensor mounting nut (2) to the hub (3).
  6. Remove the wheel speed sensor (1) from the hub (3).
    Fig 2: Wheel Speed Connector
    GC0026853Courtesy of DAIMLERCHRYSLER CORP.
    1 - ELECTRICAL CONNECTOR
    2 - CLIP
  7. Disconnect the wire sensor routing clips (2).
  8. Disconnect the wheel speed sensor wire connector (1).
  9. Remove the sensor and wire.
scientia non olet · About LEMON Manuals