Sensor-Brake Pressure: Removal
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - POWER BRAKE BOOSTER |
| 2 - FLUID RESERVOIR |
| 3 - FLUID LEVEL SENSOR ELECTRICAL CONNECTOR |
| 4 - PRESSURE SWITCH ELECTRICAL CONNECTOR |
| 5 - PRESSURE SWITCH |
| 6 - ELECTRICAL SOLENOID CONNECTOR |
| 7 - SOLENOID CONNECTOR |
| 8 - CHECK VALVE |
| 9 - FLUID LEVEL SENSOR |
- Disconnect wiring harness (4) connector from pressure switch (5).
- Remove pressure switch (5) on bottom of master cylinder.