Sensor-Brake Pressure: Installation
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - POWER BRAKE BOOSTER |
| 2 - FLUID RESERVOIR |
| 3 - FLUID LEVEL SENSOR ELECTRICAL CONNECTOR |
| 4 - PRESSURE SWITCH ELECTRICAL CONNECTOR |
| 5 - PRESSURE SWITCH |
| 6 - ELECTRICAL SOLENOID CONNECTOR |
| 7 - SOLENOID CONNECTOR |
| 8 - CHECK VALVE |
| 9 - FLUID LEVEL SENSOR |
- Install pressure switch (5) on bottom of master cylinder. Tighten switch to 28 N.m (250 in. lbs.) torque.
- Connect wiring harness (4) connector to pressure switch (5).
- Fill master cylinder fluid reservoir (2) with clean, fresh Mopar(R) Brake Fluid or equivalent.
- Perform Verification Test and clear any faults. ABS VERIFICATION TEST - VER 1 .