Diagnosis And Testing - Antilock Brakes

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

The ABS brake system performs several self-tests every time the ignition switch is turned on and the vehicle is driven. The ABM monitors the systems input and output circuits to verify the system is operating correctly. If the on board diagnostic system senses that a circuit is malfunctioning the system will set a trouble code in its memory.

NOTE: An audible noise may be heard during the self-test. This noise should be considered normal.

NOTE: The scan tool is used to diagnose the ABS system. For additional information refer to ELECTRONIC CONTROL MODULES - SERVICE INFORMATION . For test procedures refer to the BRAKE CONTROLLER ELECTRICAL DIAGNOSTICS .