Front Disc Brake Rotor

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Front rotors and hub/bearings are matched mounted for minimum lateral runout. Before removing the rotor, mark the rotor and hub/bearing to maintain original orientation.

Raise and support the vehicle.

Remove wheel and tire assembly.

Fig 1: Caliper

Courtesy of DAIMLERCHRYSLER CORP.

1 - CALIPER

2 - CALIPER BOLTS

3 - CALIPER ADAPTER BOLTS

4 - ADAPTER

5 - BRAKE HOSE

6 - BANJO BOLT WITH COPPER WASHERS

Remove the caliper adapter mounting bolts (3) and remove the caliper adapter from the steering knuckle.
Secure caliper anchor assembly to nearby suspension part with a wire. Do not allow brake hose to support caliper weight.

Fig 2: O-Ring
Courtesy of DAIMLERCHRYSLER CORP.

1 - ROTOR

2 - O-RING
Remove and discard the o-ring (2) securing the disc brake rotor (1) on the hub.
Remove the disc brake rotor from hub/bearing.