LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 535 (Mechanical Brake System - Base (Service Information)) >> Pedal >> Removal >> Non-Adjustable Pedal

Non-Adjustable Pedal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
    Fig 1: Push Rod Retainer Clip
    GC0026810Courtesy of DAIMLERCHRYSLER CORP.
    1 - RETAINER CLIP
    2 - PUSH ROD
    3 - PEDAL PIN
  2. Remove retainer clip (1) that holds booster to pedal pin (3).
  3. Remove the power brake booster (Refer to BRAKES/HYDRAULIC/MECHANICAL/POWER BRAKE BOOSTER - REMOVAL) .
    Fig 2: Intermediate Shaft Mounting Nuts
    GC0026811Courtesy of DAIMLERCHRYSLER CORP.
    1 - MOUNTING NUTS
    2 - INTERMEDIATE SHAFT
  4. Lock the steering wheel into place.
  5. Remove the 2 intermediate shaft bearing nuts (1).
  6. Remove the lower steering shaft pinch bolt.
  7. Remove the lower steering shaft off the column.
  8. Loosen the brake pedal sled upper nuts
  9. Remove the brake pedal assembly from the vehicle.
scientia non olet · About LEMON Manuals