LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 535 (Mechanical Brake System - Base (Service Information)) >> Pedal >> Removal >> Adjustable Pedals

Adjustable Pedals

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If possible put the pedals in the full forward position.
  1. Disconnect the negative battery cable.
  2. Remove the power brake booster (Refer to BRAKES/HYDRAULIC/MECHANICAL/POWER BRAKE BOOSTER - REMOVAL) .
    Fig 1: Intermediate Shaft Mounting Nuts
    GC0026811Courtesy of DAIMLERCHRYSLER CORP.
    1 - MOUNTING NUTS
    2 - INTERMEDIATE SHAFT
  3. Remove the 2 intermediate shaft bearing nuts (1).
  4. Remove the lower steering shaft pinch bolt.
  5. Remove the lower steering shaft off the column.
  6. Lock the steering wheel into place.
  7. Disconnect the pedal motor electrical connector.
    Fig 2: Adjustable Pedals Mounting
    GC0026814Courtesy of DAIMLERCHRYSLER CORP.
    1 - STUDS
    2 - SLED
    3 - ADJUSTABLE PEDALS MOTOR
    4 - NUT
  8. Disconnect the accelerator pedal cable.
  9. Disconnect the 2 accelerator pedal mounting nuts (4).
    Fig 3: Adjustable Pedals Sled
    GC0026813Courtesy of DAIMLERCHRYSLER CORP.
    1 - SLED
    2 - ACCELERATOR PEDAL
    3 - ADJUSTABLE PEDALS MOTOR
  10. Loosen the brake pedal sled (1) upper nuts
  11. Remove the brake pedal/accelerator pedal assembly (2&3) from the vehicle.
scientia non olet · About LEMON Manuals