LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 535 (Mechanical Brake System - Base (Service Information)) >> Master Cylinder >> Installation

Master Cylinder: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Bleed new master cylinder on bench before installation.
  1. Install the master cylinder with new gasket and nuts.
  2. Reconnect the brake fluid level electrical connector.
  3. Install the secondary brake tube at the HCU.
  4. Install the secondary brake tube at the master cylinder.
  5. Install the primary brake tube at the HCU.
  6. Install the primary brake tube at the master cylinder.
  7. Fill and bleed brake system.
scientia non olet · About LEMON Manuals