LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 535 (Mechanical Brake System - Base (Service Information)) >> Disc Brake Calipers >> Removal >> Rear Disc Brake Caliper

Rear Disc Brake Caliper

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle.
  2. Remove rear wheel and tire assembly.
  3. Drain small amount of fluid from master cylinder brake reservoir with a clean  suction gun.
    Fig 1: Cable To Support Plate
    GC0026804Courtesy of DAIMLERCHRYSLER CORP.
    1 - WHEEL SPEED SENSOR WIRE
    2 - CABLE
    3 - BRAKE HOSE
    4 - CALIPER SLIDE BOLTS
    5 - BANJO BOLT
  4. Bottom caliper pistons into the caliper by prying the caliper over.
  5. Remove brake hose (3) banjo bolt (5) and discard gasket washers.
  6. Remove the caliper slide pins (4).
    Fig 2: Rotor/Caliper
    GC0026803Courtesy of DAIMLERCHRYSLER CORP.
    1 - DISC BRAKE CALIPER
    2 - DISC BRAKE ROTOR
  7. Remove caliper (1) from the anchor.
  8. Remove the brake pads.
scientia non olet · About LEMON Manuals