Rear Disc Brake Caliper

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rotor/Caliper

Courtesy of DAIMLERCHRYSLER CORP.

1 - DISC BRAKE CALIPER

2 - DISC BRAKE ROTOR

Install the brake pads.
Lubricate the slide pins and slide pin bushings with caliper slide grease or the grease provided with the caliper.

Install the caliper (1) on the anchor.

Fig 2: Cable To Support Plate

Courtesy of DAIMLERCHRYSLER CORP.

1 - WHEEL SPEED SENSOR WIRE

2 - CABLE

3 - BRAKE HOSE

4 - CALIPER SLIDE BOLTS

5 - BANJO BOLT

Install the caliper slide pin bolts (4) and tighten to 35 N.m (26 ft. lbs.).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
Install brake hose (3) to caliper with a new gasket washers and tighten banjo bolt (5) to 31 N.m (23 ft. lbs.).
Fill and bleed brake system.
Install wheel and tire assemblies.
Remove supports and lower vehicle.