Rear Disc Brake Pads

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle.
Remove rear wheel and tire assembly.

Drain small amount of fluid from master cylinder brake reservoir with a clean suction gun.

Fig 1: Cable To Support Plate

Courtesy of DAIMLERCHRYSLER CORP.

1 - WHEEL SPEED SENSOR WIRE

2 - CABLE

3 - BRAKE HOSE

4 - CALIPER SLIDE BOLTS

5 - BANJO BOLT

Bottom caliper pistons into the caliper by prying the caliper over.
Remove the caliper slide pins (4).

Fig 2: Rotor/Caliper
Courtesy of DAIMLERCHRYSLER CORP.

1 - DISC BRAKE CALIPER

2 - DISC BRAKE ROTOR
Remove caliper (1) from the anchor.
Secure caliper (1) to nearby suspension part with wire. Do not allow brake hose to support caliper weight.
Remove the inboard & outboard brake pads from the caliper.