Front Disc Brake Shoes

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rotor/Caliper

Courtesy of DAIMLERCHRYSLER CORP.

1 - ROTOR

2 - CALIPER ADAPTER

3 - ANTI RATTLE CLIPS

4 - DISC BRAKE PADS

5 - DISC BRAKE CALIPER

Remove and clean all rust and debris from the anti-rattle clip mounting surfaces (3) on the brake caliper adapter (2).
Install new anti-rattle clips (3) into the caliper adapter (2).
Install the inboard and outboard brake pads (4) onto the caliper adapter (2).

Install caliper (5) on the caliper adapter (2).

Fig 2: Caliper

Courtesy of DAIMLERCHRYSLER CORP.

1 - CALIPER

2 - CALIPER BOLTS

3 - CALIPER ADAPTER BOLTS

4 - ADAPTER

5 - BRAKE HOSE

6 - BANJO BOLT WITH COPPER WASHERS

Install the caliper slide pin bolts (2) and tighten to 72 N.m (53 ft. lbs.).
Install wheel and tire assembly.
Remove support and lower vehicle.
Pump brake pedal until caliper pistons and brake pads are seated and a firm brake pedal is obtained.
Fill brake fluid.