LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 534 (Suspension System (Service Information)) >> Rear >> Track Bar >> Installation

Track Bar: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Track Bar
GC0026797Courtesy of DAIMLERCHRYSLER CORP.
1 - TRACK BAR
2 - NUT
3 - BOLT
  1. Install the track bar (1) to the vehicle.
  2. Pry in between the coil springs to install track bar bolt (3).
  3. Install the track bar bolt (3) and nut (2) in the frame bracket.
    Fig 2: Track Bar Mount
    GC0026798Courtesy of DAIMLERCHRYSLER CORP.
    1 - TRACK BAR
    2 - NUT
    3 - BOLT
  4. Install the track bar (1) into the axle bracket.
  5. Install the track bar bolt (3) and nut (2) in the axle bracket.
  6. Install the left lower shock bolt to the axle Tighten to 115 N.m (85 ft. lbs.).
  7. Remove the supports and lower the vehicle.
  8. Tighten the upper mounting nuts to 190 N.m (140 ft. lbs.). Tighten the lower mounting nuts to 190 N.m (140 ft. lbs.). with full vehicle weight. 
scientia non olet · About LEMON Manuals