LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 534 (Suspension System (Service Information)) >> Rear >> Stabilizer Link >> Installation

Stabilizer Link: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper bolt for the stabilizer link to the frame and tighten to 102 N.m (75 ft. lbs.).
  2. Install the stabilizer link to the stabilizer bar.
  3. Install the nut and tighten to 88 N.m (65 ft. lbs.).
  4. Remove the jack and lower the vehicle.
scientia non olet · About LEMON Manuals