LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 534 (Suspension System (Service Information)) >> Rear >> Stabilizer Bar >> Installation

Stabilizer Bar: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Stabilizer Bar
GC0026796Courtesy of DAIMLERCHRYSLER CORP.
1 - STABILIZER BAR
2 - STABILIZER LINK
  1. Twist and rotate to position the stabilizer bar (1) on the axle from the right rear side of the vehicle.
    Fig 2: Stabilizer Bar Clamp
    GC0026795Courtesy of DAIMLERCHRYSLER CORP.
  2. Install the retainers (2) and bolts. Ensure the bar is centered with equal spacing on both sides. Tighten the bolts to 54 N.m (40 ft. lbs.).
  3. Install the links to the stabilizer bar.
  4. Tighten the nuts at the stabilizer bar to 88 N.m (65 ft. lbs.).
  5. Install the tire and wheel assemblies.
  6. Remove support and lower the vehicle.
scientia non olet · About LEMON Manuals