Right Side

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: All torques should be done with vehicle on the ground with full vehicle weight.

Fig 1: Suspension Arms

Courtesy of DAIMLERCHRYSLER CORP.

1 - NUT

2 - UPPER SUSPENSION ARM

3 - UPPER SPRING ISOLATOR

4 - JOUNCE BUMPER RETAINER

5 - BOLT

6 - JOUNCE BUMPER

7 - UPPER FLAG BOLT

8 - LOWER FLAG BOLT

9 - LOWER SUSPENSION ARM

Position the lower suspension arm (9) in the frame rail.
Install the frame rail bracket bolt (8) and nut (1) tighten to 176 N.m (130 ft. lbs.).

Fig 2: Lower Suspension Arm
Courtesy of DAIMLERCHRYSLER CORP.

1 - BOLT

2 - NUT

3 - LOWER SUSPENSION ARM
Position the lower suspension arm (3) in the axle bracket.
Install the axle bracket bolt (1) and nut (2). Tighten to 210 N.m (155 ft. lbs.).
Remove the supports and lower the vehicle.