Clevis Bracket: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clevis Bracket

Courtesy of DAIMLERCHRYSLER CORP.

1 - SHOCK

2 - BOLT

3 - CLEVIS BRACKET

4 - BOLT/NUT

Install the clevis bracket (3) to the shock (1) and tighten to 122 N.m (90 ft. lbs.).

Fig 2: Stabilizer Link

Courtesy of DAIMLERCHRYSLER CORP.

1 - NUT

2 - BOLT

3 - STABILIZER LINK

4 - OUTER TIE ROD END

5 - NUT

6 - BOLT

Install the lower stabilizer link bolt (6) and tighten to 115 N.m (85 ft. lbs.).

Fig 3: Clevis Bracket

Courtesy of DAIMLERCHRYSLER CORP.

1 - SHOCK

2 - BOLT

3 - CLEVIS BRACKET

4 - BOLT/NUT

Install the lower clevis bolt/nut (4) at the lower control arm and tighten to 169 N.m (125 ft. lbs.).

Fig 4: Knuckle Separated

Courtesy of DAIMLERCHRYSLER CORP.

1 - UPPER CONTROL ARM

2 - UPPER BALL JOINT

3 - KNUCKLE

4 - UPPER BALL JOINT NUT

Install the upper ball joint (2) into the knuckle (3) and tighten the nut to 75 N.m (55 ft. lbs.).

Fig 5: Caliper

Courtesy of DAIMLERCHRYSLER CORP.

1 - CALIPER

2 - CALIPER BOLTS

3 - CALIPER ADAPTER BOLTS

4 - ADAPTER

5 - BRAKE HOSE

6 - BANJO BOLT WITH COPPER WASHERS

Install the disc brake rotor.
Install the caliper adaptor mounting bolts (3) to 25 N.m (18 ft. lbs.).
Install the tire and wheel assembly.
Lower the vehicle.