LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 531 (Instrument Cluster) >> SEATBELT Indicator >> Standard Procedure >> Standard Procedure - Enhanced SEATBELT Reminder Programming >> Customer Programming Sequence

Customer Programming Sequence

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The following sequence of events must occur within sixty (60) seconds of the ignition switch being placed in the On position in order for the programming to be completed successfully.
  1. With the ignition switch in any position except On or Start, buckle the driver side front seat belt.
  2. Turn the ignition switch to the On position and wait for the seatbelt indicator reminder function to conclude (about seven seconds).
  3. Unbuckle and buckle the driver side front seat belt three or more times, ending with the belt buckled.
  4. Turn the ignition switch to any position except On or Start to toggle the beltminder feature from its current setting (from active to inactive, or from inactive to active). A single chime tone will provide an audible confirmation that the programming sequence has been successfully completed.
scientia non olet · About LEMON Manuals