LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Power Distribution) >> IOD Fuse >> Removal

IOD Fuse: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

The Ignition-Off Draw (IOD) fuse is disconnected from Junction Block fuse cavity # 34 when the vehicle is shipped from the assembly plant. Dealer personnel must reconnect the IOD fuse when the vehicle is being prepared for delivery in order to restore full electrical system operation.

  1. Turn the ignition switch to the Off position.
  2. Remove the fuse access panel by unsnapping it from the outboard end of the instrument panel.
  3. Grasp the outer tabs of the IOD fuse holder unit in fuse cavity # 34 of the Junction Block between the thumb and forefinger and pull the unit firmly outward.
  4. Install the fuse access panel by snapping it onto the outboard end of the instrument panel.
scientia non olet · About LEMON Manuals