Ignition Coil: Installation: 3.7L
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Using compressed air, blow out any dirt or contaminants from around top of spark plug.
- Check condition of coil o-ring and replace as necessary. To aid in coil installation, apply silicone to coil o-ring.
- Position ignition coil into cylinder head opening and push onto spark plug. Do this while guiding coil base over mounting stud.
- Install coil mounting stud nut. Refer to TORQUE - IGNITION SYSTEM .
- Connect electrical connector to coil by snapping into position.
- If necessary, install throttle body air tube or box.