LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 524 (Starting System) >> Starter Motor >> Installation >> 3.7L V-6

3.7L V-6

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position front of starter towards rear of vehicle with solenoid position rotated until it is located below starter. Install starter by passing it between exhaust pipe and transmission bellhousing.
  2. Position starter into bellhousing and install 2 bolts. Refer to SPECIFICATIONS  .
  3. Install battery cable and nut to stud on starter solenoid. Refer to SPECIFICATIONS  .
  4. Install solenoid wire connector to solenoid terminal.
  5. Position starter heat shield and install nut at front of starter.
  6. Install 2 starter heat shield bolts at side of starter.
  7. Install front propeller shaft.
  8. Install 2 flange bolts securing left exhaust downpipe to crossover pipe.
  9. Lower vehicle.
  10. Connect negative battery cable.
scientia non olet · About LEMON Manuals