LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 524 (Starting System) >> Starter Motor >> Installation >> 2.8L - Diesel

2.8L - Diesel

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: STARTER - DIESEL
GC0046814Courtesy of DAIMLERCHRYSLER CORP.
1 - STARTER/SOLENOID ASSEMBLY
2 - MOUNTING BOLTS (3)
  1. Position starter motor (1) to transmission housing.
    Fig 2: STARTER ELECTRICAL CONNECTORS - DIESEL
    GC0046815Courtesy of DAIMLERCHRYSLER CORP.
    1 - BATTERY CABLE NUT
    2 - SOLENOID TERMINAL CONNECTOR
    3 - SOLENOID
    4 - BATTERY CABLE
  2. Connect battery cable solenoid terminal wire harness connector (2) to connector receptacle on starter solenoid. Always support starter motor during this process. Do not let starter motor hang from wire harness.
  3. Install battery cable eyelet terminal (4) onto solenoid B (+) terminal stud.
  4. Install nut (1) securing battery cable eyelet terminal to starter solenoid B (+) terminal stud and tighten to 11 N.m (100 in. lbs.).
    Fig 3: STARTER - DIESEL
    GC0046814Courtesy of DAIMLERCHRYSLER CORP.
    1 - STARTER/SOLENOID ASSEMBLY
    2 - MOUNTING BOLTS (3)
  5. Position starter motor and install three bolts (2). Tighten 3 bolts in this sequence: top bolt, bottom bolt, middle bolt to 27 N.m (20 ft. lbs.).
  6. Lower vehicle.
  7. Connect negative battery cable.
scientia non olet · About LEMON Manuals