LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 523 (Wiring Diagram Information) >> Diode >> Installation

Section 523 (Wiring Diagram Information): Diode: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the insulation from the wires in the harness. Only remove enough insulation to solder in the new diode.
  2. Install the new diode in the harness, making sure current flow is correct. If necessary, refer to the SYSTEM WIRING DIAGRAMS for current flow. See Figure.
  3. Solder the connection together using rosin core type solder only. Do not use acid core solder. 
  4. Tape the diode to the harness using electrical tape. Make sure the diode is completely sealed from the elements.
  5. Re-connect the battery and test affected systems.
scientia non olet · About LEMON Manuals