LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 521 (Audio System & Video System) >> Antenna Body & Cable >> Installation >> Export

Antenna Body & Cable: Installation: Export

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, SIDE AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Connect antenna cable to the instrument panel antenna cable.
  2. Install antenna cable to the roof panel by pressing retaining clips into position.
  3. Connect antenna cable to the antenna module.
  4. Raise headliner into position.
  5. Install A-pillar trim (Refer to BODY/INTERIOR/A-PILLAR TRIM - INSTALLATION) .
  6. Install the right side sunvisor (Refer to BODY/INTERIOR/SUN VISOR - INSTALLATION) .
  7. Install the assist handles (Refer to BODY/INTERIOR/ASSIST HANDLE - INSTALLATION) .
  8. Connect the battery negative cable.
scientia non olet · About LEMON Manuals