LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 521 (Audio System & Video System) >> Antenna Body & Cable >> Installation >> Domestic

Antenna Body & Cable: Installation: Domestic

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attached wire to new cable. Pull fender out and insert cable into opening.
  2. Pull cable through hole in kick panel area using the attached wire.
  3. Connect antenna body cable to the instrument panel cable.
  4. Install right kick panel trim.
  5. Install bezel adapter.
  6. Install mounting nut.
  7. Install cover.
  8. Install antenna mast. Tighten to 50 N.m (37 ft. lbs.). Ensure that the antenna mast is fully seated on antenna base and that there is no gap between the mast and base. 
  9. Tighten fender mounting bolts near door hinge area.
  10. Install and tighten the upper fender mounting bolts (Refer to BODY/EXTERIOR/FRONT FENDER - INSTALLATION) .
  11. Connect the battery negative cable.
scientia non olet · About LEMON Manuals