Crankshaft Position Sensor: Installation
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - RETAINING BOLT |
| 2 - WASHER |
| 3 - CRANKSHAFT POSITION (CKP) SENSOR |
| 4 - ENGINE BLOCK |
- Lubricate o-ring on crankshaft position sensor and install sensor in engine block. See Fig 1.
- Install crankshaft position sensor retaining bolt. See Fig 1. Torque bolt to 10.8N.m.(95 in.lbs.).
- Connect crankshaft position sensor electrical connection.
- Install the heat shield. Tighten fasteners to 10.8N.m.(95 in.lbs.).
- Connect exhaust pipe to turbocharger downpipe. Torque bolts to 32.4N.m.(24 ft.lbs.).
- Lower vehicle from hoist.
- Connect negative battery cable.