LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 520 (Fuel System) >> Fuel Injection - 2.8L Diesel >> Boost Pressure Sensor >> Installation

Boost Pressure Sensor: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install sensor and retaining bolts into cylinder head cover/intake manifold. See Figure. Torque to 5.4 N.m (48 in. lbs.).
  2. Connect sensor electrical connector. See Figure.
  3. Install engine cover and bracket assembly (Refer to INSTALLATION (2.4L) or INSTALLATION (2.8L) or INSTALLATION (3.7L)).
  4. Connect negative battery cable.
scientia non olet · About LEMON Manuals