LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 520 (Fuel System) >> Fuel Injection - 2.8L Diesel >> Accelerator Pedal Position Sensor >> Removal

Accelerator Pedal Position Sensor: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: ACCELERATOR PEDAL POSITION SENSOR
GC0025700Courtesy of DAIMLERCHRYSLER CORP.
1 - BRAKE PEDAL
2 - APP SENSOR
  1. Disconnect negative battery cable.
  2. Disconnect accelerator pedal position sensor electrical connector. See Fig 1.
  3. Remove accelerator pedal position sensor assembly mounting bolts
  4. Open accelerator pedal position sensor assembly and disconnect accelerator cable
  5. Remove accelerator pedal position sensor assembly.
scientia non olet · About LEMON Manuals