Throttle Position Sensor: Removal: 3.7L

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

The Throttle Position Sensor (TPS) is mounted to the throttle body, or See Fig 1.Fig 2.

Disconnect TPS electrical connector.
Remove 2 TPS mounting screws.
Remove TPS.

Fig 1: Locating Idle Air Control Motor & TPS - 3.7L V-6

Courtesy of DAIMLERCHRYSLER CORP.

1 - THROTTLE POSITION SENSOR (TPS)

2 - MOUNTING SCREWS

3 - IDLE AIR CONTROL MOTOR (IAC)

4 - MOUNTING SCREWS

Fig 2: TPS Installation - 3.7L

Courtesy of DAIMLERCHRYSLER CORP.

1 - THROTTLE BODY

2 - TPS

3 - THROTTLE BODY SHAFT

4 - SOCKET LOCATING TANGS