LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 520 (Fuel System) >> Fuel Injection - 2.4L/3.7L Gas >> Idle Air Control Motor >> Installation >> 2.4L

Idle Air Control Motor: Installation: 2.4L

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

The Idle Air Control (IAC) motor is located on the rear side of the throttle body.

  1. Install IAC motor to throttle body.
  2. Install and tighten two mounting bolts (screws) to 7 N.m (60 in. lbs.) torque.
  3. Install electrical connector.
scientia non olet · About LEMON Manuals