LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 520 (Fuel System) >> Fuel Injection - 2.4L/3.7L Gas >> Crankshaft Position Sensor >> Installation >> 3.7L

Crankshaft Position Sensor: Installation: 3.7L

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean out machined hole in engine block.
  2. Apply a small amount of engine oil to sensor o-ring.
  3. Install sensor into engine block with a slight rocking and twisting action.
    CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result.
  4. Install mounting bolt and tighten to 28 N.m (21 ft. lbs.) torque.
  5. Connect electrical connector to sensor.
  6. Lower vehicle.
scientia non olet · About LEMON Manuals