LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 519 (Message Systems) >> Electronic Vehicle Info Center >> Installation

Electronic Vehicle Info Center: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the EVIC module onto the overhead console housing.
  2. Install and tighten the four screws that secure the EVIC module to the overhead console housing. Tighten the screws to 0.9 N.m (8 in. lbs.).
  3. Install the overhead console onto the headliner.
  4. Reconnect the battery negative cable.
NOTE: IF A NEW EVIC COMPUTER HAS BEEN INSTALLED, THE COMPASS WILL HAVE TO BE CALIBRATED AND THE VARIANCE SET. REFER TO STANDARD PROCEDURE - COMPASS VARIATION ADJUSTMENT  AND STANDARD PROCEDURE - COMPASS CALIBRATION  FOR DETAILED INSTRUCTIONS.
NOTE: IF A NEW EVIC COMPUTER HAS BEEN INSTALLED, THE TIRE PRESSURE SENSORS WILL HAVE TO BE REPROGRAMMED. REFER TO TIRES/WHEELS FOR DETAILED INSTRUCTIONS.
scientia non olet · About LEMON Manuals