LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 518 (Battery System) >> Battery Tray >> Installation

Battery Tray: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the battery tray. (Refer to ELECTRICAL/BATTERY SYSTEM - CLEANING) .
  2. Position the battery tray onto the weld studs on the front extension of the left front wheelhouse inner panel.
  3. Install and tighten the three nuts that secure the battery tray to the weld studs on the front extension of the left front wheelhouse inner panel. Tighten the nuts to 7 N.m (65 in. lbs.).
  4. Install the PDC on the battery tray.
  5. Install the battery onto the battery tray. (Refer to ELECTRICAL/BATTERY SYSTEM/BATTERY - INSTALLATION) .
scientia non olet · About LEMON Manuals