LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 518 (Battery System) >> Battery HOLDDOWN >> Installation

Battery HOLDDOWN: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the battery hold down hardware. Refer to CLEANING  for the proper battery system component cleaning procedures, and Battery Inspection for the proper battery system component inspection procedures.
  2. Position the battery hold down bracket onto the battery tray.
  3. Install and tighten the battery hold down bracket retaining bolt. Tighten the bolt to 4 N.m (35 in. lbs.).
  4. Reconnect the battery negative cable terminal clamp to the battery negative terminal post. Tighten the terminal clamp pinch-bolt hex nut to 8.4 N.m (75 in. lbs.).
scientia non olet · About LEMON Manuals