LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Lighting Systems - Exterior) >> Repeater Lamp >> Installation >> Lamp

Repeater Lamp: Installation: Lamp

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Side repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
  1. Position the repeater lamp unit to the front fender panel. See Figure.
  2. Reconnect the wire harness connector to the lamp socket.
  3. Position the lamp unit into the mounting hole in the front fender panel. Be certain that the clearance notch on the edge of the lamp lens is oriented towards the bottom.
  4. Using hand pressure, press on the lamp lens firmly and evenly until the snap features of the lamp are fully engaged in the mounting hole of the front fender panel.
  5. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals