Repeater Lamp: Installation: Bulb
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.
NOTE:
Side repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
- Align the base of the bulb with the repeater lamp socket.
- Push the bulb straight into the socket until the base is firmly seated.
- Align the socket and bulb with the keyed opening on the back of the repeater lamp lens. See Figure.
- Insert the socket and bulb straight into the lens until the socket is firmly seated
- Rotate the socket clockwise in the lens about 30 degrees to lock it into place.
- Reinstall the repeater lamp unit onto the front fender panel. (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/REPEATER LAMP UNIT - INSTALLATION) .
- Reconnect the battery negative cable.