Lamp - North AMERICA

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the battery negative cable.

Remove the two screws that secure the license plate lamp unit to the rear bumper fascia. See Fig 1.

Fig 1: License Plate Lamp Unit Remove/Install

Courtesy of DAIMLERCHRYSLER CORP.

1 - REAR BUMPER FASCIA

2 - LICENSE PLATE LAMP UNIT

3 - SCREW (2)

Lower the lamp from the mounting hole in the fascia far enough to access and disconnect the lamp pigtail wire connector.
Remove the license plate lamp unit from the vehicle.