Lamp - Export

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the battery negative cable.
Remove the bulb and socket from the license plate lamp unit that is being removed. (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/LICENSE PLATE LAMP BULB - REMOVAL - REST-OF-WORLD) .

Remove the two screws that secure the lamp unit to the back of the license plate bracket. See Fig 1.

Fig 1: License Plate Lamp Remove/Install - Export

Courtesy of DAIMLERCHRYSLER CORP.

1 - LAMP UNIT (2)

2 - LICENSE PLATE BRACKET

3 - SCREW (4)

4 - BULB & SOCKET (2)

Remove the lamp unit from the back of the license plate bracket.