LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Lighting Systems - Exterior) >> Lamp-High Mounted Stop >> Installation >> Lamp

Lamp-High Mounted Stop: Installation: Lamp

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check to be certain that the two plastic nuts are properly positioned and in good condition on each side of the roof panel opening for the Center High Mounted Stop Lamp (CHMSL). See Figure.
  2. Position the CHMSL near the roof panel opening.
  3. Reconnect the wire harness connector to the CHMSL socket.
  4. Install and tighten the two screws that secure the CHMSL to the roof panel. Tighten the screws to 2 N.m (21 in. lbs.).
  5. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals