Lamp Bar: Removal: Cover

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Light Bar Lamp Cover Remove/Install

Courtesy of DAIMLERCHRYSLER CORP.

1 - COVER

2 - SCREW (4)

3 - LIGHT BAR

Remove the four screws that secure the cover to the rear edge of the light bar reinforcement on the roof panel. See Fig 1.
Lift the rear edge of the cover upward and then slide it forward far enough to disengage the front edge of the cover from under the front edge of the light bar reinforcement.
Remove the light bar cover from the roof panel.